RENT / RTS ZEUS II
€200.00
Tax excluded
The Zeus DSP Matrix Intercom System not only provides superior performance and reliability for all your communications
needs, but can also function as the heart of a complete audio mixing/routing and control systems for many facilities.
The RTS Zeus DSP Matrix intercom system provides 24 channels of high-quality audio in a compact 2-rack unit package. Each
channel is capable of supporting any of the RTS line of matrix keypanels, or Four-Wire inputs and outputs for program and IFB
feeds.
The Zeus system comes complete with AZedit, Windows based, full-featured configuration software, providing online and offline
configuration capabilities. Meet any communication need without rewiring, jumper changes, or the need to take the system offline.
Most changes can be made through the use of one of RTS’ intelligent keypanels, where the more involved changes can
be achieved either on or offline through the use of AZedit.
Zeus also comes standard with full support for Point-to-Point communications, party line conferences, IFBs, ISOlate, and
special lists. With 8 GPI/Os, control of external devices, including two-way radios, VOXs, tally and alarm indicators, is greatly
increased. A back panel serial port is also provided for connection of RTS accessories including additional GPI, level control
panels, conference assign panels, and program assign panels.
Zeus Specifications
Power Input
IEEC power connector with fuse and power switch. Internal switching power supply accepts 90-250 VAC, 50/60 Hz, 60 Watts max.
Controls and Indicators
Power On / Off toggle switch, located on back panel
Reset push button switch, recessed in front panel
Diagnostic push button switches (2), recessed in front panel
Power On indicator
General Status Indicator
Keypanel Status indicators (24)
Zeus controller status indicator
Zeus audio status indicator
Zeusedit status indicator
UIO-256 status indicator
LCP-102 status indicator
Miscellaneous diagnostic indicators (19, for service only)
Note: all indicators located on front panel
Analog Audio Specifications
Signal Type: Fully differential (balanced)
Nominal Level: 8 dBu
Maximum Level: 20 dBu
Input Impedance: High (22 kΩ)
Output Impedance: Low (600Ω)
A/D and D/A Specifications: Sampling Rate: 44.1 kHz
Resolution: 20 Bits
Converter Architecture: 128x Oversampling D-S Modulator
Audio Performance
SNR at 20 dBu: (A-weighted): > 90 dB
THD+N at 20 dBu, 1 kHz (Unweighted): < 0.007%
Frequency Response at 20 dBu: within ± 1 dB from 50Hz – 20 kHz
Crosstalk at 20 dBu: < -80 dB
CMRR: > 85 dB
All measurements performed using an Audio Precision System 1
Dual Domain System. Measurements were performed using a sine wave at: f = 1 kHz and Level = 20 dBu. Measurement bandwidth = 20 Hz to 20 kHz.
Connections
Intercom Channels (J1 to J24)
General: 4-wire, balanced audio; RS-485 data for optional intelligent keypanels
Connector type: 9-pin male D-sub (DE-9P)
Pin 1: Keypanel data +; Pin 2: Keypanel data -; Pin 3: Audio out shield; Pin 4: Audio in + (high); Pin 5: Audio in – (low); Pin 6: Keypanel data shield; Pin 7:Audio out – (low); Pin 8: Audio out + (high); Pin 9:Audio in shield
Configuration Computer (J25)
General: RS-232 Serial port
Connector type: 9-pin female D-sub (DE-9S)
Pin 2: RX; Pin 3: TX; Pin 5: Ground
Accessory Connector (J26)
General: An RS-485 data port for LCP-102 / PAP /UIO-256 connection.
Connector type: 9-pin female D-sub (DE-9S)
Pin 1: LCP-102 / PAP / UIO-256 RS-485 data -; Pin 2: ground; Pin 3: N/C; Pin 4: N/C; Pin 5: N/C; Pin 6: LCP-102 / PAP / UIO-256 RS-485 data +; Pin 7: ground; Pin 8: N/C; Pin 9: N/C
GPI (General Purpose Interface) Connector (J27)
General: Provides 8 control inputs which can simulate keypanel keys, and 8 control outputs which can be assigned to keys and used to activate external devices. Connector type: 25-pin female D-sub
Physical/Power
Power Requirements: 90-250 VAC, 50/60 Hz, 60W
Size: 3.5” H x 19” W x 17 D” (88.9mm H x 482.6mm W x431.8 D)
Weight: 10.14 lbs (4.6 kg)
You might also like
22 other products in the same category:
The Zeus DSP Matrix Intercom System not only provides superior performance and reliability for all your communications
needs, but can also function as the heart of a complete audio mixing/routing and control systems for many facilities.
The RTS Zeus DSP Matrix intercom system provides 24 channels of high-quality audio in a compact 2-rack unit package. Each
channel is capable of supporting any of the RTS line of matrix keypanels, or Four-Wire inputs and outputs for program and IFB
feeds.
The Zeus system comes complete with AZedit, Windows based, full-featured configuration software, providing online and offline
configuration capabilities. Meet any communication need without rewiring, jumper changes, or the need to take the system offline.
Most changes can be made through the use of one of RTS’ intelligent keypanels, where the more involved changes can
be achieved either on or offline through the use of AZedit.
Zeus also comes standard with full support for Point-to-Point communications, party line conferences, IFBs, ISOlate, and
special lists. With 8 GPI/Os, control of external devices, including two-way radios, VOXs, tally and alarm indicators, is greatly
increased. A back panel serial port is also provided for connection of RTS accessories including additional GPI, level control
panels, conference assign panels, and program assign panels.